jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

NEXT PAGE > < PREV PAGE
Page 1
background image

Leak Detection Pump: Service and Repair

REMOVAL

The NVLD pump (2) is attached to the EVAP canister (3). This assembly is located in the left-rear quarter-panel behind the left-rear tire.

1. Raise and support vehicle.
2. Remove left-rear tire.
3. To access EVAP canister or NVLD pump, remove plastic splash shield at rear of left-rear tire.
4. Disconnect electrical connector (4) at pump.
5. Carefully remove vapor/vacuum hoses at pump.

6. Pry outward on tab (3) and rotate pump clockwise about 70 degrees for removal.

Powertrain Management > Emission Control Systems > Evaporative Emissions System > Leak Detection Pump, Evaporative System > Component Information > Locations > Page 3088

NEXT PAGE > < PREV PAGE