Commander 4WD V8-4.7L VIN N (2006)
Fuel Injector: Description and Operation
An individual fuel injector (1) is used for each individual cylinder.
The top (fuel entry) end of the injector (3) is attached into an opening on the fuel rail.
The fuel injectors are electrical solenoids. The injector contains a pintle that closes off an orifice at the nozzle end. When electric current is supplied to
the injector, the armature and needle move a short distance against a spring, allowing fuel to flow out the orifice. Because the fuel is under high pressure,
a fine spray is developed in the shape of a pencil stream. The spraying action atomizes the fuel, adding it to the air entering the combustion chamber.
The nozzle (outlet) ends of the injectors (2) are positioned into openings in the intake manifold just above the intake valve ports of the cylinder head.
The engine wiring harness connector for each fuel injector is equipped with an attached numerical tag (INJ 1, INJ 2 etc.). This is used to identify each
fuel injector.
The injectors are energized individually in a sequential order by the Powertrain Control Module (PCM). The PCM will adjust injector pulse width by
switching the ground path to each individual injector on and off. Injector pulse width is the period of time that the injector is energized. The PCM will
adjust injector pulse width based on various inputs it receives.
Battery voltage is supplied to the injectors through the ASD relay.
The PCM determines injector pulse width based on various inputs.
