Commander 4WD V8-4.7L VIN N (2006)
9. Press tab (3) to release plastic cable mount from bracket. Press on tab only enough to release cable from bracket. If tab is pressed too much, it will
be broken. Slide plastic mount (2) towards passenger side of vehicle to remove cable from bracket.
10. Remove throttle cable from vehicle.
INSTALLATION
1. Slide accelerator cable plastic mount into bracket. Continue sliding until tab (3) is aligned to hole in mounting bracket.
2. Route accelerator cable over top of cable cam.
3. Connect cable end to throttle body bellcrank pin (snaps on rearward).
4. Slide rubber grommet away from plastic cable housing.
5. Install rubber grommet (3) into dash panel until seated.
6. Push cable housing into rubber grommet and through opening in dash panel.
7. From inside vehicle, slide throttle cable core wire into opening (6) in top of pedal arm.
8. Push cable retainer (clip) (2) into pedal arm opening until it snaps in place.
9. Snap cable into dashpanel routing clip.
10. Install air resonator tube to throttle body.
11. Before starting engine, operate accelerator pedal to check for any binding.
