Commander 4WD V8-4.7L VIN N (2006)
Manifold Pressure/Vacuum Sensor: Service and Repair
REMOVAL
The Manifold Absolute Pressure (MAP) sensor (1) is mounted into the front of the intake manifold.
1. Disconnect electrical connector at sensor.
2. Clean area around MAP sensor.
3. Remove two sensor mounting screws.
4. Remove MAP sensor from intake manifold.
5. Check condition of sensor O-ring (2)
INSTALLATION
The Manifold Absolute Pressure (MAP) sensor is mounted into the front of the intake manifold. An O-ring (2) is used to seal the sensor to the intake
manifold.
1. Clean MAP sensor mounting hole at intake manifold.
2. Check MAP sensor O-ring seal for cuts or tears.
3. Position sensor into manifold.
4. Install MAP sensor mounting bolts (screws). Refer to Torque Specifications.
5. Connect electrical connector.