Commander 4WD V8-4.7L VIN N (2006)
Keyless Entry Module: Service and Repair
MODULE-SENTRY KEY REMOTE ENTRY
WARNING: TO AVOID PERSONAL INJURY OR DEATH, ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE
SUPPLEMENTAL RESTRAINT SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, AIRBAG,
OCCUPANT CLASSIFICATION SYSTEM, SEAT BELT TENSIONER, IMPACT SENSOR, OR INSTRUMENT PANEL COMPONENT
DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO
MINUTES FOR THE SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS
THE ONLY SURE WAY TO DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM. FAILURE TO TAKE THE PROPER
PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT.
REMOVAL
1. Disconnect and isolate the battery negative cable
NOTE: The Sentry Key REmote Entry Module (SKREEM) can be removed from the ignition lock housing without disconnecting the Brake
Transmission Shift Interlock (BTSI) cable.
2. Lower the ignition key cylinder, lock housing (2) and switch (3) from the instrument panel as an assembly far enough to access the SKREEM
mounting bracket.
3. Remove the screw (4) that secures the SKREEM mounting bracket to the ignition lock housing.
4. Disengage the SKREEM antenna ring (1) from around the ignition lock housing and remove the SKREEM.
INSTALLATION
1. Position the Sentry Key REmote Entry Module (SKREEM) onto the ignition lock housing (2) with the SKREEM antenna ring (1) oriented around
the lock cylinder.
