Commander 4WD V8-4.7L VIN N (2006)
during that time period (first 6 seconds), abort/recovery is not available and the EBC module will be permanently disabled and will require
replacement.
NOTE:
The StarSCAN tool must be at version 8.03 or higher before this procedure can be performed. The software release level is visible in the blue header
at the top of the StarSCAN screen.
1.
Open the hood and install a battery charger. Verify that the charging rate provides approximately 13.5 volts.
2.
Use the following procedure to determine the EBC Module software part number:
a.
Connect the StarSCAN to the vehicle data link connector and turn the ignition key to the "RUN" position.
b.
Power ON the StarSCAN.
c.
From the StarSCAN "Home" screen, select "ECU View".
d.
From the StarSCAN "ECU View" screen, select "ABS Antilock Brakes" from the list of modules.
e.
Select "More Options".
f.
Select "ECU Flash".
g.
Record the old EBC module "Part Number" displayed at the end of the "Resident flash file for" statement near the top of "Flash ABS"
screen for later reference.
3.
Connect the CH9410 ethernet cable to the StarSCAN and the dealer's network drop.
4.
Select "Browse for New File" and follow the on-screen instructions.
5.
If the newly downloaded flash file "Part Number" in the StarSCAN is:
>
the same as the number recorded in Step 2g, then the EBC module is up to date. No further action is required. Turn off and disconnect the
battery charger. Then disconnect the StarSCAN from the vehicle.
>
different than the number recorded in Step 2g, the EBC module requires updating. Continue with Step 6 of this procedure.
6.
Highlight the calibration and then select "Download to Scantool".
7.
Select "Close" after the download is complete, disconnect the ethernet cable from the scan tool and then select "Back".
8.
Highlight the listed calibration.
9.
Select "Update Controller" and follow the on-screen instructions.
10.
When the EBC module update is complete, select "OK".
11.
Verify the part number (resident flash file) at the top of the screen has updated to the new part number.
12.
Press the "BACK" button four times to return to the "Home" screen.
13.
Turn the ignition key to the "OFF" position and wait 10 seconds.
14.
Turn the ignition key to the "RUN" position (engine not running).
15.
After completing the EBC control module reprogramming, clear all Diagnostic Trouble Codes (DTC's) using the following procedure:
a.
Select "System View".
b.
Select "All DTC".
c.
Select "Clear All Stored DTC's" and follow the on-screen instructions.
d.
Select "YES" in the pop-up box.
e.
Start the engine and verify that there are no DTC's.
