Commander 4WD V8-4.7L VIN N (2006)
14.
Highlight "ECU View" and press the "Select" button.
15.
Highlight "ABS" and press the "Select" button.
16.
Select "Flash ECU" and press the "Select" button.
17.
Push the "Select" button to start the reprogramming process and follow the on-screen screen instructions.
18.
When the flash is complete, press the "OK" button.
19.
Verify the part number (resident flash file) at the top of the screen has updated to the new part number.
20.
Clear all Diagnostic Trouble Codes (DTC's) using the following procedure:
a.
Return to the "HOME" screen (press the "BACK" button three times).
b.
Turn the ignition key to the "OFF" position and wait 10 seconds.
c.
Turn the ignition key to the "RUN" position (engine not running).
d.
From the "Home" screen highlight "All DTC's" and press the "Select" button.
e.
Highlight the "Clear All Stored," press the "Select" button, and follow the on-screen instructions.
f.
Start the vehicle and check for DTC's.
21.
Disconnect the StarMOBILE scan tool and battery charger from the vehicle.
