Commander 4WD V8-4.7L VIN N (2006)
5. Using hand pressure, push the integral retainer of the horn switch pigtail wire connector (3) into the locator hole just above the upper left inflator
mounting stud on the back of the airbag housing.
6. Reconnect the driver airbag jumper harness connector (2) to the horn switch pigtail wire connector (3).
7. After the driver airbag has been assembled, try pulling the trim cover and the airbag housing away from each other. This action will fully seat the
edges of the windows into the cradles of the hooks and engage the side walls of the trim cover receptacle under the engagement tabs.
8. Before reinstalling the airbag onto the steering wheel, check that the blocking tab (4) in each of the trim cover (1) windows is oriented over the
air-bag housing hook (3), and the engagement tab (2) on each side of the housing is oriented over the side wall of the trim cover receptacle as
shown.
9. Reinstall the driver airbag onto the steering wheel.
WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE. PERSONAL INJURY OR DEATH MAY RESULT IF THE
SYSTEM TEST IS NOT PERFORMED FIRST. FOR THE SYSTEM TEST, See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Supplemental Restraints
Verification Test
