Commander 4WD V8-4.7L VIN N (2006)
5. Remove the screw (4) that secures the seat belt turning loop (5) to the height adjuster (2).
6. Remove the seat belt turning loop from the height adjuster.
7. Remove the upper trim (3) from the inside of the B-pillar (1).
8. Remove the trim (8) from the lower B-pillar.
9. Pull the front seat belt (6) turning loop and lower anchor through the seat belt opening in the lower B-pillar trim.
10. Remove the screw (7) that secures the retractor (9) lower bracket to the base of the inner B-pillar. 11. Remove the front seat belt and retractor from
the vehicle as a unit.
INSTALLATION
1. Be certain that the retractor shield (10) is properly installed in the inner B-pillar (1) and in good condition before installing the retractor.
2. Position the seat belt and retractor (9) into the vehicle as a unit.
3. Install and tighten the screw (7) that secures the retractor lower bracket to the base of the inner B-pillar. Tighten the screw to 39 N.m (29 ft. lbs.).
4. Route the front seat belt (6) turning loop and lower anchor through the seat belt opening in the lower B-pillar trim (8).
5. Reinstall the lower trim onto the B-pillar.
6. Reinstall the upper trim (3) onto the inside of the B-pillar.
