Commander 4WD V8-4.7L VIN N (2006)
Technical Service Bulletin # F04
Date: 060501
Recall - 3rd Row Seat Belt Bracket Cover Defect
Revised May 2006
Dealer Service Instructions for:
Safety Recall F04
Third Row Seat Belt Bracket Cover
NOTE:
The seat belt part number table has been revised.
Models
2006 (XK) Jeep(R) Commander
NOTE:
This notification applies only to the above vehicles built through October 6, 2005 (MDH 100612).
IMPORTANT:
Some of the involved vehicles may be in dealer new vehicle inventory. Federal law requires you to complete this recall service on these vehicles
before retail delivery. Dealers should also consider this requirement to apply to used vehicle inventory and should perform this recall on vehicles in
for service. Involved vehicles can be determined by using the VIP inquiry process.
Subject
The 3rd row outboard seat belts on about 24,000 of the above vehicles may rub against the side of the seat belt bracket and fray at the edges. This could
cause the seat belt to fail in certain crash conditions, which can increase the risk of injury to passengers in these seating positions.
Repair
A plastic cover must be installed over the right and left third row seat belt bracket. If either seat belt is frayed at the edges, it must be replaced.
Parts Information
Completion Reporting and Reimbursement
Claims for vehicles that have been serviced must be submitted on the DealerCONNECT Claim Entry Screen located on the Service tab. Claims
submitted will be used by DaimlerChrysler to record recall service completions and provide dealer payments.
