Commander 4WD V8-4.7L VIN N (2006)
26.
Remove the seat belt retractor assembly bolt below the pull strap from the back of the seat back frame (Figure 7).
29.
Position the third row seat belt and retractor assembly into the top of the pocket on the front upper outboard corner of the seat back frame. Be
certain to engage the tab on the retractor into the slot within the pocket.
30.
Install and tighten the seat belt retractor assembly bolt below the pull strap from the back of the seat back frame that secures the retractor. Tighten
the screw to 32 ft-lbs (43 N.m) (Figure 7).
31.
Position the retractor retainer bracket over the top of the retractor pocket on the front upper outboard corner of the seat back frame (Figure 6).
32.
Install and tighten the retractor bolt that secures the retainer bracket to the top of the retractor pocket on the seat back frame. Tighten the bolt to 32
ft-lbs (43 N.m) (Figure 6).
33.
Install seat belt bracket cover (PN CEC0F040) over the retractor retainer bracket (Reference Figure 3).
34.
Install the plastic bolster/cover and tighten the two screws.
35.
Pull the seat fabric and foam cushion up and insert the head rest stanchions through the holes in the fabric.
36.
Install the seat fabric starting at the outboard corner of the seat frame top.
37.
Pull the seat back assist strap through the fabric opening.
38.
Hook the inboard, outboard, and upper rear plastic tabs of the seat back fabric into the rear of the seat back frame anchor slots.
39.
Insert the three plastic panel clips removed in Step 28 into the slot-hole of the seat back trim panel.
40.
Install seat back trim panel.
41.
Install grocery bag hook panel onto the back seat trim panel.
42.
Install the bolt holding the seat belt lower anchor (Figure 4) to the outboard rear corner of the third row seat support bracket. Tighten to 32 ft-lbs
(43 N.m) (Figure 5).
43.
Install the plastic seat belt trim cover and tighten the two screws.
44.
Install the seat pivot trim cover and tighten screw.
45.
Lift the seat assembly into the vehicle.
46.
Latch the front hooks to the striker and lower the rear seat assembly onto the studs and locator pins (Figure 4).
47.
Install the center bolt and tighten to 37 ft-lbs (50 N.m) (Figure 4).
48.
Install the outer nuts and tighten to 37 ft-lbs (50 N.m). (Figure 4)
49.
Install the cargo storage bin and tighten the two nuts.
50.
Install the lift gate scuff plate and tighten screws.
51.
Install the cargo storage bin lid.
