Commander 4WD V8-4.7L VIN N (2006)
INSTALLATION
1. Position the front seat belt buckle and tensioner (1) lower anchor onto the stud on the inboard side of the seat cushion frame.
2. Install and tighten the nut that secures the front seat belt buckle lower anchor to the side of the front seat. Tighten the nut to 43 N.m (32 ft. lbs.).
3. If so equipped, reconnect the seat belt switch pigtail wire connector (3) to the seat wire harness connector for the seat belt switch.
4. Reconnect the seat wire harness connector (2) to the seat belt tensioner initiator.
5. Reinstall the side shield onto the inboard side of the front seat cushion.
6. Reinstall the console onto the floor panel transmission tunnel.
7. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component.
