Commander 4WD V8-4.7L VIN N (2006)
1. Position the seat belt turning loop adjuster (5) to the inside of the B-pillar (6).
2. Install and tighten the two screws (1) that secure the adjuster to the B-pillar. Tighten the screws to 39 N.m (29 ft. lbs.).
3. Reinstall the upper trim (2) onto the inside of the B-pillar.
4. Position the seat belt turning loop (4) onto the height adjuster on the upper B-pillar. Be certain that the seat belt webbing between the retractor and
the turning loop is not twisted.
5. Install and tighten the screw (3) that secures the turning loop to the height adjuster. Tighten the screw to 39 N.m (29 ft. lbs.).
6. Insert the upper tabs of the turning loop trim cover into the slots of the height adjuster on the upper B-pillar, then lower the bottom of the cover
and use hand pressure to press firmly and evenly on the cover until it snaps into place.
