Commander 4WD V8-4.7L VIN N (2006)
7. Position the seat belt turning loop (5) onto the height adjuster (2) on the upper B-pillar. Be certain that the seat belt webbing between the retractor
and the turning loop is not twisted.
8. Install and tighten the screw (4) that secures the turning loop to the height adjuster. Tighten the screw to 39 N.m (29 ft. lbs.).
9. Insert the upper tabs of the turning loop trim cover into the slots of the height adjuster on the upper B-pillar, then lower the bottom of the cover
and use hand pressure to press firmly and evenly on the cover until it snaps into place.
10. Position the seat belt lower anchor to the mounting hole on the outboard side of the front seat cushion frame. Be certain that the seat belt webbing
between the turning loop and the lower anchor is not twisted.
11. Install and tighten the screw (2) that secures the lower anchor to the seat. Tighten the screw to 39 N.m (29 ft. lbs.).
12. Reinstall the lower anchor cover (1) onto the front seat cushion outboard side shield.
