Commander 4WD V8-4.7L VIN N (2006)
1. Fold and tumble the second row outboard seat forward against the front seat for easiest access to the seat belt lower anchor and the C-pillar trim.
2. Loosen the screw (9) that secures the second row outboard seat belt lower anchor (6) and the seat latch striker bracket (8) to the rear floor panel.
3. Disengage the lower anchor from the loosened seat latch striker bracket screw.
4. Remove the upper trim (3) from the inside of the C-pillar.
5. Pull the second row seat belt (4) and lower anchor through the seat belt opening in the upper C-pillar trim.
6. Remove the trim from the quarter inner panel.
7. Remove the screw (11) that secures the seat belt turning loop (2) to the upper C-pillar (1).
8. Remove the seat belt turning loop from the upper C-pillar.
9. Remove the screw (5) that secures the retractor (7) to the lower C-pillar.
10. Disengage the retractor locator tab from the slot in the lower C-pillar.
11. Remove the second row outboard seat belt and retractor from the lower C-pillar as a unit.
INSTALLATION
1. Be certain that the retractor shield (1) is properly installed in the inner C-pillar and in good condition before installing the retractor.
2. Position the second row outboard seat belt (4) and retractor (7) to the lower C-pillar as a unit.
