Commander 4WD V8-4.7L VIN N (2006)
Seat Belt Retractor: Service and Repair
Third Row
SEAT BELT AND RETRACTOR
THIRD ROW
WARNING: DURING AND FOLLOWING ANY SEAT BELT OR CHILD RESTRAINT ANCHOR SERVICE, CAREFULLY INSPECT
ALL SEAT BELTS, BUCKLES, MOUNTING HARDWARE, RETRACTORS, TETHER STRAPS, AND ANCHORS FOR PROPER
INSTALLATION, OPERATION, OR DAMAGE. REPLACE ANY BELT THAT IS CUT, FRAYED, OR TORN. STRAIGHTEN ANY BELT
THAT IS TWISTED. TIGHTEN ANY LOOSE FASTENERS. REPLACE ANY BELT THAT HAS A DAMAGED OR INOPERATIVE
BUCKLE OR RETRACTOR. REPLACE ANY BELT THAT HAS A BENT OR DAMAGED LATCH PLATE OR ANCHOR PLATE.
REPLACE ANY CHILD RESTRAINT ANCHOR OR THE UNIT TO WHICH THE ANCHOR IS INTEGRAL THAT HAS BEEN BENT OR
DAMAGED. NEVER ATTEMPT TO REPAIR A SEAT BELT OR CHILD RESTRAINT COMPONENT. ALWAYS REPLACE DAMAGED
OR FAULTY SEAT BELT AND CHILD RESTRAINT COMPONENTS WITH THE CORRECT, NEW AND UNUSED REPLACEMENT
PARTS LISTED IN THE DAIMLERCHRYSLER MOPART PARTS CATALOG.
REMOVAL
1. Remove the third row seat from the vehicle.
2. Remove the screw (5) that secures the seat belt lower anchor (4) to the outboard rear corner of the third row seat support bracket (1).
3. Remove the two screws (4) that secure the seat belt escutcheon (1) to the top of the third row seat back (5).
4. Slide the seat belt webbing (2) through the slot (3) in the escutcheon to remove the escutcheon from the belt.
5. Remove the trim from the back and the top of the third row seat back frame.
