Commander 4WD V8-4.7L VIN N (2006)
1. Position the third row seat belt and retractor as a unit through the top of the pocket on the front upper outboard corner of the seat back frame. Be
certain to engage the tab on the retractor into the slot within the pocket.
2. Install and tighten the screw (3) below the pull strap (1) from the back of the seat back frame (2) that secures the retractor. Tighten the screw to 43
N.m (32 ft. lbs.).
3. Position the retractor retainer bracket (2) over the top of the retractor pocket (4) on the front upper outboard corner of the seat back frame (3).
4. Install and tighten the through bolt (1) that secures the retainer bracket to the top of the retractor pocket on the seat back frame. Tighten the bolt to
43 N.m (32 ft. lbs.).
5. Reinstall the trim onto the top and the back of the third row seat back frame.
