Commander 4WD V8-4.7L VIN N (2006)
1. Position the side impact sensor (2) onto the inner B-pillar (1). Be certain that the anti-rotation pin on the back of the sensor is engaged in the
clearance hole of the B-pillar.
2. Install and tighten the two screws (3) that secure the sensor to the inner B-pillar. Tighten the screws to 8 N.m (70 in. lbs.).
3. Reconnect the body wire harness connector (4) to the sensor connector receptacle.
4. Reinstall the lower trim onto the inside of the B-pillar.
5. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component.
