Commander 4WD V8-4.7L VIN N (2006)
Cavity numbers are stamped on the connector.
Measure the voltage at cavity 1 of the 2-way liftgate ajar switch connector.
Is the voltage above 10 volts?
Yes >> Further diagnosis is required, this service bulletin does not apply.
No >> Proceed to Step # 5
Turn ignition key off.
Swap wires in the 2-way liftgate ajar switch connector. Cavity 1 should contain the "G78 - liftgate ajar switch sense circuit and cavity 2 should
contain the "Ground circuit.
Reimbursable within the provisions of the warranty.
This bulletin is supplied as technical information only and is not an authorization for repair.