jeep Workshop Repair Guides

Jeep Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 1
background image

Yaw Rate Sensor: Service and Repair

SENSOR-DYNAMICS

REMOVAL

1. Remove the center console.
2. Disconnect electrical connector (3) from the dynamics sensor (1).
3. Remove the two nuts (2) securing the sensor to the floor.
4. Remove the sensors.

INSTALLATION

1. Install the dynamics sensor (1) to the vehicle.
2. Install the electrical connector (3)
3. Install the two retaining nuts (2) and tighten to 9 Nm (80 inch lbs.).
4. Install the floor console.

Sensors and Switches > Sensors and Switches - Brakes and Traction Control > Yaw Rate Sensor > Component Information > Description and Operation > Page 773

< PREV PAGE NEXT PAGE >