Commander 4WD V8-4.7L VIN N (2006)
Ambient Temperature Sensor / Switch HVAC: Service and Repair
SENSOR-AMBIENT AIR TEMPERATURE
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Remove the grille.
3. Disconnect the wire harness connector (1) from the ambient air temperature sensor (2) located at the top of the front bumper beam (3).
4. Disengage the ambient air temperature sensor from the retaining tabs (4) and remove the sensor.
INSTALLATION
1. Install the ambient air temperature sensor (2) onto the top of the front bumper beam (3). Make sure that the retaining tabs (4) are fully engaged.
2. Connect the wire harness connector (1) to the ambient air temperature sensor.
3. Install the grille.
4. Reconnect the negative battery cable.
