Commander 4WD V8-4.7L VIN N (2006)
Power Steering Pump: Service and Repair
Removal and Installation
PUMP
REMOVAL
1. Siphon power steering reservoir.
2. Remove the cooler return hose at the reservoir.
3. Disconnect the pressure hose nut at the pump.
4. Remove the pressure hose at the pump.
5. Remove serpentine drive belt.
6. Remove 3 pump mounting bolts (1).
7. Remove pulley from pump if necessary.
INSTALLATION
1. Install pulley on pump if removed.
2. Install 3 pump mounting bolts (1) and tighten to 28 Nm (21 ft. lbs.).
3. Install the drive belt.
4. Install the pressure hose on the pump and tighten the nut to 28 Nm (21 ft. lbs.).
5. Install the cooler return hose at the reservoir.
6. Add power steering fluid.
