Commander 4WD V8-4.7L VIN N (2006)
5. Separate the lower ball joint (3) from the steering knuckle (1) using special tool 8677 (2).
6. Remove the steering knuckle.
7. Remove the clevis bracket and move the halfshaft to the side and support the halfshaft out of the way 4X4 only.
NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure
proper operation during the removal and installation process.
8. Press the ball joint from the lower control arm (3) using special tools C-4212-F (PRESS) (1), C-4212-3 (Driver) (2) and 9654-3 (Receiver) (4).
INSTALLATION
NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure proper
operation during the removal and installation process.
1. Install the ball joint (4) into the control arm (3) and press in using special tools C-4212-F (press) (1), 9654-1 (Driver) (5) and 9654-2 (Receiver)
(2).
2. Stake the ball joint flange in four evenly spaced places around the ball joint flange, using a chisel and hammer.
3. Remove the support for the halfshaft and install into position, then install the clevis bracket. 4X4 only.
4. Install the steering knuckle.
5. Install the tie rod end into the steering knuckle.
6. Install and tighten the halfshaft nut to 251 Nm (185 ft. lbs.). (If Equipped).
7. Install the brake caliper and rotor.
8. Install the tire and wheel assembly.
9. Check the vehicle ride height.
10. Perform a wheel alignment.
