Commander 4WD V8-4.7L VIN N (2006)
NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure
proper operation during the removal and installation process.
6. Press the ball joint from the upper control arm (1) using special tools C-4212-F (PRESS) (2) and 9652 (Driver) (3).
INSTALLATION
NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure proper
operation during the removal and installation process.
1. Install the ball joint (4) into the upper control arm (5) and press in using special tools C-4212-F (press) (2), 9652 (Driver) (1) and 8975-2
(Receiver) (4).
