Commander 4WD V8-4.7L VIN N (2006)
Stabilizer Link: Service and Repair
Rear Suspension
STABILIZER LINK
REMOVAL
1. Raise and support the vehicle.
2. Remove the rear tire.
3. Support the rear axle with a jack.
4. Remove the upper link bolt at the frame.
5. Remove the lower link nut at the stabilizer bar.
6. Remove stabilizer link.
INSTALLATION
1. Install the upper bolt for the stabilizer link to the frame and tighten to 102 Nm (75 ft. lbs.).
2. Install the stabilizer link to the stabilizer bar.
3. Install the nut and tighten to 122 Nm (90 ft. lbs.).
4. Remove the jack and lower the vehicle.
