Commander 4WD V8-4.7L VIN N (2006)
Differential Cover: Service and Repair
Rear Axle - C213R
DIFFERENTIAL COVER
REMOVAL
1. With vehicle in neutral, position on hoist.
2. Remove differential cover (1) fill plug (2).
3. Remove differential cover (1) and drain fluid.
INSTALLATION
1. Apply a 6.35mm (1/4 inch) bead of Mopar Gear Sealant RTV Silicone Rubber Adhesive MS-GF44D or equivalent to the cover.
CAUTION: If housing cover is not installed within 3 to 5 minutes, the cover must be cleaned and new RTV applied. Failure to follow these
instructions will result in a leak.
2. Install cover and tighten cover (1) bolts in a crisscross pattern to 41 Nm (30 ft. lbs.).
3. Fill differential and install fill plug (2).
