Commander 4WD V8-4.7L VIN N (2006)
flange onto the pinion.
3. Install new pinion collared nut and carefully tighten nut in stages holding flange (1) with flange Wrench C-3281(2). Check torque to rotate after
each stage, until previously value of torque to rotate is exceeded by 0.5 Nm (4.4 inch lbs.).
4. Cut the pinion nut collar.
5. Bend nut collar so it touches the wall of the slot in the pinion shaft.
6. Connect propeller shaft to pinion flange.
7. Install wheel and tires.
8. Operate brake pedal several times until brake pads contact brake discs (brake pressure built up).
Seal-Differential
SEAL-DIFFERENTIAL
REMOVAL