Commander 4WD V8-4.7L VIN N (2006)
1. Install axle flange bolts into axle flange.
2. Tap axle shaft through axle bearing into wheel flange.
3. Install axle shaft (1) into axle tube and backing plate with new O-ring on axle.
4. Slip O-ring (2) through backing plate, then push axle through backing plate until bearing (1) is exposed.
5. Install O-ring (2) axle bearing.
6. Push axle into axle tube.
7. Install axle (2) flange nuts (1) and tighten to 119 Nm (88 ft. lbs.).