Commander 4WD V8-4.7L VIN N (2006)
5. Pull axle shaft and backing plate out of axle tube until axle bearing (1) is exposed.
6. Remove O-ring (2) from the axle bearing.
7. Remove axle shaft (1) from axle tube and backing plate.
INSTALLATION
1. Install axle shaft (1) into axle tube and backing plate with new O-ring on axle.
2. Slip O-ring (2) through backing plate, then push axle through backing plate until bearing (1) is exposed.
3. Install new O-ring (2) on axle bearing (1).
