Commander 4WD V8-4.7L VIN N (2006)
Seals and Gaskets: Service and Repair
Seal-Rear Output Shaft
SEAL-REAR OUTPUT SHAFT
REMOVAL
1. Remove the rear propeller shaft.
2. Using Holder C-3281 (1), remove the rear companion flange (2) nut.
3. Remove the rear output shaft flange (1) from the output shaft (2). If necessary, use a suitable 2 or 3 jaw puller to remove the output shaft flange.
4. Remove the rear output shaft seal with a suitable pry tool or a screw mounted in a slide hammer.
INSTALLATION
1. Install a new rear output shaft seal into the rear cover with Installer 6952-A.
2. Install the rear output shaft flange (1) onto the output shaft (2).
