Commander 4WD V8-4.7L VIN N (2006)
Quarter Window Glass: Service and Repair
QUARTER GLASS
REMOVAL
NOTE: Grand Cherokee (WK) shown, Commander (XK) similar.
1. Before proceeding with the following repair procedure, review all warnings and cautions. Refer to Windows and Glass / Service Precautions.
2. Remove the quarter panel trim from the side of the vehicle being serviced. Refer to Trim Panel.
CAUTION: Be careful not to damage painted surfaces when removing moldings or cutting urethane around the windshield.
3. Using razor knife, cut the urethane adhesive that secures the quarter glass to window fence.
4. Carefully push the quarter window glass from the opening.
INSTALLATION
WARNING: Do not operate the vehicle within 24 hours of quarter glass installation. It takes at least 24 hours for urethane adhesive to cure. If
it is not cured, the quarter glass may not perform properly if the vehicle is in an accident.
CAUTION:
-
To help prevent water leaks, partially roll down the left and right door glass before installing the quarter glass. This avoids pressurizing
the passenger compartment if a door is slammed before the urethane is cured.
-
Protect all painted and trimmed surfaces from coming in contact with urethane or primers.
NOTE: Grand Cherokee (WK) shown, Commander (XK) similar.
