Commander 4WD V8-4.7L VIN N (2006)
6.
Remove the water shield from the door. While the water shield is temporarily removed, the adhesive seal on the water shield must remain clean
and not become contaminated.
7.
Verify that the window regulator assembly is properly attached to the inner door panel. Tighten the five (5) attaching bolts to 8.8 N-m (75 in. lbs)
(Fig. 2).
8.
Verify that the window glass run channel is properly attached to the inner door panel. Tighten the upper nut and the lower screw to 10 N-m (90 in.
lbs) (Fig. 3).
