Commander 4WD V8-4.7L VIN N (2006)
e.
Check that the window glass reverses when in the express-up mode by holding a pen in the path of the glass.
f.
Once the proper operation of the express-up feature has been verified, clear all Diagnostic Trouble Codes (DTC's).
g.
If the Condition(s) persist, continue to Step 2.
2.
Disconnect and isolate the negative battery cable from the battery.
3.
Verify that the window opening weatherstrip is fully seated around the entire window opening and at the bottom of the door pillar.
4.
Inspect door glass seals as follows depending on the vehicle being serviced:
a.
(WK/WH): Inspect window seal flocking on seals at A & B pillars. Ensure flocking extends all the way to the edge of the seal. If the seal is
smooth (no flocking) anywhere seal contacts glass, replace only defective seal(s), p/n's 55394052AK (Right) and 55394053AK (Left)
b.
(XK/XH): Inspect window seal slipcoat at A & B pillars. (XK/XH) use a smooth seal. If the seal has any excessive bumps or gouges
anywhere seal contacts glass, replace only defective seal(s), p/n's 55396696AE (Right) and 55396697AE (Left).
5.
Remove the door trim panel (Fig 1).
6.
Remove the water shield from the door. While the water shield is temporarily removed, the adhesive seal on the water shield must remain clean
and not become contaminated.
