Commander 4WD V8-4.7L VIN N (2006)
PARTS REQUIRED
CLEANING PROCEDURE:
1.
Moisten a clean cloth with water.
2.
Wipe the glass surface leaving a very fine film of water on the glass.
3.
Observe the location of the marks on the glass.
4.
If the marks are on the inside of the glass surface, take precautions to cover any of the interior components the cleanser could come in contact
with.
5.
Rinse the cloth with clean water.
6.
Apply cleanser to the moist cloth.
7.
Rub the surface of the glass with the cleanser in a circular pattern being sure to cover the entire area that the mark involves.
8.
Wash off any residual cleanser material with a moist cloth.
9.
Dry the glass surface.
10.
Check that the removal has been successful by rubbing a moistened, clean cloth back over the cleaned surface and inspect for suction cup marks.
11.
Repeat as necessary to remove all of the mark(s) from the glass surface(s).
POLICY:
Information Only
Disclaimer
This bulletin is supplied as technical information only and is not an authorization for repair.
