Commander 4WD V8-4.7L VIN N (2006)
3. Install new adhesive backed spacers (4) along the windshield fence as required.
4. Install a new rubber seal (2) along the top of the windshield (1).
5. Using an assistant, position the windshield into the windshield opening and against the windshield fence (3) and spacers.
6. Verify the windshield lays evenly against the fence at the top, bottom and sides of the opening. If not, the fence must be formed to the shape of the
windshield.
7. Mark the windshield and the windshield fence with a grease pencil or pieces of masking tape to use as a reference for installation.
8. Using an assistant, remove the windshield from the windshield opening and place it on a suitable padded work surface.
WARNING: Do not use solvent based glass cleaners to clean the windshield before applying glass prep and primer or poor glass
adhesion may result.
9. Clean the inside of the windshield with an ammonia based glass cleaner and a lint-free cloth.
10. Apply glass prep adhesion promoter 25 mm (1 in.) wide (1) around the perimeter of the windshield (2) and 5 mm (0.2 in.) from the edge of the
glass and wipe dry with a clean lint-free cloth until no streaks are visible.
11. Apply glass primer 25 mm (1 in.) wide (1) around the perimeter of the windshield (2) and 5 mm (0.2 in.) from the edge of the glass. Allow at
least three minutes drying time.
12. Using a flashlight, verify that the primer is completely and evenly installed along the perimeter of the windshield.
13. Re-prime any area that is not fully and evenly primed.
14. Clean the windshield fence with an ammonia based glass cleaner and a lint-free cloth.
15. Apply pinch weld primer 15 mm (0.75 in.) wide (1) around the windshield fence (2). Allow at least three minutes drying time.
16. Using a flashlight, verify that the primer is completely and evenly installed along the windshield fence.
17. Re-prime any area that is not fully and evenly primed.
