Commander 4WD V8-4.7L VIN N (2006)
Wiper Arm: Service and Repair
Wiper Arm Park Lamp
WIPER ARM PARK RAMP
REMOVAL
1. Remove the rear wiper arm from the wiper arm park ramp (5) and the rear wiper motor output shaft (3).
2. Remove the screw (6) that secures the park ramp to the liftgate outer panel.
3. Remove the wiper arm park ramp from the liftgate outer panel.
INSTALLATION
1. Check to be certain that the rivet nut (4) is properly installed and in good condition in the liftgate outer panel. Replace the rivet nut, if required.
2. Position the wiper arm park ramp (5) over the rivet nut on the liftgate outer panel.
3. Install and tighten the screw (6) that secures the park ramp to the liftgate outer panel. Tighten the screw to 6 N.m (55 in. lbs.).
4. Reinstall the rear wiper arm onto the park ramp and the rear wiper motor output shaft (3).
