Commander 4WD V8-4.7L VIN N (2006)
1. Position the rear wiper motor and mounting bracket into the liftgate as a unit with the two mounting screws (3) loosened.
2. Insert the motor output shaft (1) through the hole in the liftgate outer panel and engage the two mounting screws into the keyed holes in the bracket
within the liftgate.
3. From the outside of the liftgate, install the bezel (2) over the motor output shaft (3) and engage it in the mounting hole of the liftgate outer panel.
4. Install and tighten the nut (1) that secures the bezel and the output shaft to the liftgate outer panel. Tighten the nut to 5 N.m (43 in. lbs.).
5. From the inside of the liftgate, tighten the two screws that secure the motor mounting bracket to the bracket within the liftgate. Tighten the screws
to 6 N.m (50 in. lbs.).
6. Reconnect the liftgate wire harness connector to the wiper motor connector receptacle.
7. Reinstall the trim panel onto the liftgate inner panel.
8. Reinstall the rear wiper arm onto the output shaft.
9. Reconnect the battery negative cable.
