Commander 4WD V8-4.7L VIN P Flex Fuel (2007)
Map Light Bulb: Service and Repair
Removal
Bulb - Front
BULB - FRONT
1. Disconnect and isolate the battery negative cable.
2. Using a small thin-bladed screwdriver, gently pry the switch end of the reading lamp lens (2) away from the lamp housing (1) far enough to unsnap
the switch end of the lens from the housing. The switch end of the lens is identified by a tactile concave depression (3).
3. Swing the switch end of the lens (2) out and away from the lamp housing (1) until it is perpendicular to the lamp.
4. Starting at the switch end of the lamp, depress each of the three retainers (3) that secure the reflector (4) and disengage the reflector from the three
locating pins within the lamp housing.
5. Pull the base of the bulb (1) straight out of the bulb holder (2) within the lamp housing.