Compass 2WD L4-2.0L VIN 0 (2007)
8. Remove the retaining clip (2) securing the power brake booster push rod (1) to the brake pedal. To do so, position a small screwdriver under the
center tang of the retaining clip, then rotate the screwdriver enough to allow the retaining clip tang to pass over the end of the brake pedal pin (3).
Remove and discard the clip. Do not reuse the clip.
9. Slide the booster push rod (1) off the brake pedal pin (3).
10. Remove the four nuts (4) attaching the brake pedal (1) (and power brake booster) to the dash panel.
11. Remove the remaining nut (5) attaching the brake pedal (1) to the dash panel.
12. Remove the brake pedal (1).
