Compass 2WD L4-2.0L VIN 0 (2007)
Crankshaft Main Bearing Seal: Service and Repair
Removal
REMOVAL
1. Remove transaxle
2. Remove flex plate bolts and discard.
3. Remove flex plate (1).
4. Insert a 3/16 flat bladed screwdriver (7) between the dust lip (8) and the metal case (4) of the crankshaft seal (1). Angle the screwdriver through
the dust lip against metal case of the seal. Pry out seal.
CAUTION: Do not permit the screwdriver blade to contact crankshaft seal surface. Contact of the screwdriver blade against crankshaft
edge (chamfer) is permitted.
5. Check to make sure the seals garter spring is not on the crankshaft.
