Compass 2WD L4-2.4L (2008)
Backing Plate: Service and Repair
Installation
INSTALLATION
1. Assemble the hub and bearing (3) through the support plate (2) and install the spacer (1) on the rear of the assembly.
2. Install the hub and bearing (3), support plate (2), and spacer (1) as an assembly on the trailing link.
NOTE: When performing the following step, use NEW mounting bolts or clean and apply Mopar(R) Stud & Bearing Mount Adhesive or
equivalent to the original mounting bolt threads before reuse.
3. Install the four bolts (8) securing the hub and bearing (5), support plate (2), and spacer (7) to the trailing link (1). Tighten the mounting bolts to
105 Nm (77 ft. lbs.).
4. Insert the parking brake cable into its mounting hole in the brake support plate. Push the cable housing in until the retainer's fingers lock into place.