Compass 2WD L4-2.4L (2008)
Seat Occupant Classification Module - Air Bag: Service and Repair
Occupant Restraint Controller (ORC) Module - Removal
REMOVAL
WARNING: To avoid serious or fatal injury on vehicles equipped with side curtain or seat airbags, disable the Supplemental Restraint System
(SRS) before attempting any Occupant Restraint Controller (ORC) diagnosis or service. The ORC contains a rollover sensor, which enables the
system to deploy the side curtain and seat airbags in the event of a vehicle rollover event. If an ORC is accidentally rolled during service while
still connected to battery power, the side curtain and seat airbags will deploy. Disconnect and isolate the battery negative (ground) cable, then
wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the
SRS. Failure to take the proper precautions could result in accidental airbag deployment.
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service.
Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing
further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental
airbag deployment.
WARNING: To avoid serious or fatal injury, never strike or drop the Occupant Restraint Controller (ORC), as it can damage the impact
sensor or affect its calibration. The ORC contains the impact sensor, which enables the system to deploy the SRS components. If an ORC is
accidentally dropped during service, the module must be scrapped and replaced with a new unit. Failure to observe this warning could result in
accidental, incomplete, or improper SRS component deployment.
NOTE: Several different Occupant Restraint Controllers (ORC) are available for this vehicle. For vehicles equipped with the optional side
curtain or seat airbags the ORC contains a second bi-directional safing sensor.
1. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
2. Remove the center console shifter housing from the top of the floor panel transmission tunnel. See: Body and Frame/Interior Moulding /
Trim/Console/Service and Repair/Center Console Shifter Housing - Removal.
3. Lift, but do not remove, the jute covered panel (1) over the Occupant Restraint Controller (ORC) (2) between the dash panel and the gearshift
mechanism as necessary to access the ORC connections and fasteners.
