Compass 2WD L4-2.4L (2008)
Ignition Switch Lock Cylinder: Service and Repair
Ignition Key / Lock Cylinder
Removal
REMOVAL
WARNING: Disconnect and isolate the battery negative (ground) cable before beginning steering wheel removal or installation. Allow the front
airbag system capacitor to discharge for two minutes before removing the steering wheel or any front airbag system component. This will
disable the front airbag system. Failure to disconnect the battery could result in accidental front airbag module deployment and possible
personal injury.Do not place a non-deployed airbag face down on a hard surface as the airbag will propel into the air if accidentally deployed,
and could result in serious or fatal injury.
1. Remove air cleaner fresh air duct (2) and disconnect and isolate negative battery cable at battery, See: Starting and Charging/Battery/Service and
Repair/Removal and Replacement/Battery - Removal.
2. Remove upper (1) and lower (2) steering column shrouds,See: Steering and Suspension/Steering/Steering Column/Steering Column Cover/Service
and Repair/Shroud - Upper/Removal.