Compass 2WD L4-2.4L (2008)
1. Install the power steering return hose (7) into the engine compartment.
2. Install the return hose routing clamp screw (1) securing the return hose (7) to the strut tower.
3. Install the return hose onto the cooler tubes (5) and install the hose clamps (6).
4. Raise and support the vehicle. See: Maintenance
5. Install the screw (2) securing the return hose to the frame rail. Tighten the screw to 19 Nm (14 ft. lbs.).
6. Install the return hose (1) at the return tube (2).
7. Lower the vehicle.
8. Install the front fascia. See: Body and Frame/Bumper/Front Bumper/Front Bumper Cover / Fascia/Service and Repair/Front Fascia - Installation
9. Install the windshield washer reservoir. See: Wiper and Washer Systems/Windshield Washer Reservoir/Service and Repair/Washer Reservoir -
Installation
10. Install the power steering fluid reservoir. See: Power Steering Fluid Reservoir/Service and Repair/Power Steering Fluid Reservoir - Installation
11. Install the coolant recovery bottle. See: Engine, Cooling and Exhaust/Cooling System/Coolant Reservoir/Service and Repair/Coolant Recovery
Container - Installation
12. Fill and bleed the power steering system. See: Power Steering Bleeding/Service and Repair
13. Check for leaks.
14. Install the engine appearance cover.
Supply Hose - Gas Engine
GAS ENGINE