Compass 2WD L4-2.4L (2008)
CAUTION: Never use impact or high speed tools to remove the strut rod nut. Damage to the strut internal bearings can occur.
9. Install Strut Nut Wrench (2), Special Tool 9362, on the strut rod nut. Next, install Strut Shaft Socket (1), Special Tool 9894, on the end of the strut
rod. While holding the strut rod from turning, tighten the strut rod nut to 60 Nm (44 ft. lbs.) using a torque wrench on the end of Special Tool
9362.
10. Slowly release the tension from the coil spring by backing off the compressor (1) drive completely. As the tension is relieved, make sure the upper
mount and bearing align properly. Verify the upper mount does not bind when rotated.
11. Remove the strut assembly from the spring compressor.
12. Install the strut assembly on the vehicle. See: Installation
Installation
INSTALLATION