Compass 2WD L4-2.4L (2008)
Seals and Gaskets: Service and Repair
Axle Seal
Removal
REMOVAL
1. Remove axle shaft. See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Half Shaft - Removal
2. Insert a flat-blade pry tool (2) at outer edge of axle shaft seal (1).
3. Tap on the pry tool (2) with a small hammer and remove axle shaft seal (1).
Installation
INSTALLATION
1. Clean axle shaft seal bore of any excess sealant.
2. Align (bellhousing side) axle shaft seal with axle shaft seal bore.