Compass 4WD L4-2.0L (2009)
3. If removed, connect the outer demister duct (1) to the driver side demister duct (3).
4. Position the driver side instrument panel duct (6) and demister duct to the instrument panel support and connect the driver side instrument panel
duct to the passenger side instrument panel duct (5). Make sure the ducts are fully engaged to each other.
5. Connect the demister hose (4) to the driver side demister duct. Make sure the hose is fully engaged to the duct.
6. Install the four screws (2 and 7) that secure driver side instrument panel duct and demister duct to the instrument panel support. Tighten the screws
to 2.2 Nm (20 in. lbs.).
7. Install the lower and upper instrument panel covers See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Instrument Panel Cover - Installation.
Instrument Panel Demister Duct - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow
these instructions may result in accidental airbag deployment and possible serious or fatal injury.
NOTE: LHD model shown in illustrations. RHD model similar.
DRIVER SIDE
NOTE: The inner driver side demister duct is serviced only as an assembly with the driver side instrument panel duct.
1. Remove the upper and lower instrument panel covers See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Instrument Panel Cover - Removal.
2. Remove the four screws (2 and 7) that secure the driver side demister duct (3) and the instrument panel duct (6) to the instrument panel support.
3. Disconnect the driver side demister hose (4) from the demister duct.
4. Disconnect the driver side instrument panel duct from the passenger side instrument panel duct (5).
5. Remove the instrument panel and demister duct assembly from the instrument panel support.
6. If required, disconnect the outer demister duct (1) from the driver side demister duct.