Grand Cherokee 2WD L6-4.0L VIN S (1997)
Cruise Control Servo: Service and Repair
REMOVAL
1. Disconnect negative battery cable at battery.
Servo Electrical Connector Location
2. Disconnect vacuum hose at servo.
3. Unplug electrical connector at servo.
4. Remove 2 mounting nuts holding servo cable sleeve to bracket.
5. Pull speed control cable sleeve away from servo to expose cable retaining clip.
6. Block throttle to full open position.
7. Remove clip attaching cable to servo.
8. Remove servo from mounting bracket.
INSTALLATION
1. Position servo to mounting bracket.
2. Block throttle to full open position to align hole in cable connector with hole in servo pin. Install cable-to-servo retaining clip.
3. Install servo mounting nuts and tighten to 8.5 N.m (75 in. lbs.).
4. Connect vacuum hose at servo.
5. Connect electrical connector at servo.
6. Remove throttle block.
7. Connect negative battery cable to battery.