Grand Cherokee 2WD L6-4.0L VIN S (1997)
Control Arm Bushing: Service and Repair
REMOVAL
1. Remove the upper suspension arm from axle
2. Position Receiver 7932-1 (J-35581-1), or equivalent over the bushing in the axle and install Bushing Removal/Installer.
3. Remove the bushing by tightening the Long Nut.
NOTE: Do not remove Receiver 7932-1 (J-35581-1) at this time.
INSTALLATION
1. Position new bushing, Receiver and Installer on axle.
2. Install the bushing by tightening the Long Nut.
3. Remove tools and install the upper suspension arm.