Grand Cherokee 2WD L6-4.0L VIN S (1997)
5. Invert retainer and press input shaft in opposite direction until snap-ring is seated.
6. Install new seals on clutch piston. Be sure lip of each seal faces interior of clutch retainer.
7. Lubricate lip of piston seals with generous quantity of MOPAR Door Ease. Then lubricate retainer hub and bore with light coat of transmission
fluid.
8. Install clutch piston in retainer. Use twisting motion to seat piston in bottom of retainer. A thin strip of plastic (about 0.020" thick), can be used to
guide seals into place if necessary.
CAUTION: Never push the clutch piston straight in. This will fold the seals over causing leakage and clutch slip. In addition, never use any type
of metal tool to help ease the piston seals into place. Metal tools will cut, shave, or score the seals.
9. Install piston spring in retainer and on top of piston. Concave side of spring faces downward (toward piston).
10. Install wave spring in retainer. Be sure spring is completely seated in retainer groove.
11. Install bottom pressure plate. Ridged side of plate faces downward (toward piston) and flat side toward clutch pack.
12. Install first clutch disc in retainer on top of bottom pressure plate. Then install a clutch plate followed by a clutch disc until entire clutch pack is
installed (4 discs and 3 plates are required).
13. Install top pressure plate.
14. Install selective snap ring. Be sure snap ring is fully seated in retainer groove.